Magnepan MMC 2 Bedienungsanleitung

MMC 2 INSTALLATION INSTRUCTION MANUALTABLE OF CONTENTS:A. SELECTION OF SPEAKER LOCATIONB. PAINTING SPEAKER FRAMESC. WALL PREPARATIOND. TOP FRAME I

K. SPEAKER ANGLE ADJUSTMENTSome of the adjustments below are easier if the motor is pulled back using a strip of duct tape as described abovein Final

the MMC 2. To ensure that the nylon screw will not loosen, wrap Teflon plumber's tape on the threads or a drop ofblue Loctite or score the thread

L. Phasing1. Correct phasing between a "small" speaker, like the MMC 2, and the Bass Panel is much more difficult todetect than an out-of-

phasing between the MMC 2s and your Bass Panel. The pink noise CD is "shaped" with a 9 db peak at80-100 Hz. This aids in the detection of an

4. Install the speaker trim in the edge of the speaker with a rubber mallet. (Masking tape over the trim will helpprevent marring of the finish from

C. TIPS FROM THE PROS FOR DO-IT-YOURSELFERS1. To run a speaker wire into a wall and out another hole at the bottom, insert a fine steel chain in the

Fig. 2

D. TOP FRAME INSTALLATION1. Thread motor wires through the 1/4" dia. center hole and attach the top frame using keyholes on the back ofthe top

E. ATTACHING BOTTOM FRAME TO SPEAKER1. Caution-- Do not rest the weight of the speaker panel on the speaker wires. Under extreme force, the steeltub

F. BOTTOM FRAME ATTACHMENT TO WALL1. While keeping the bottom frame and speaker together, take the speaker to the wall for installation. See Fig. 7.

G. FINAL SPEAKER INSTALLATIONMany of the adjustments and installation are much easier with the aid of an LED headlamp.The final step is the most diff

a file or Dremel tool to allow the frame to be lowered on one side. However, the head of the pan-head screwwill impact on the interior portion of the