Magnepan MC1 Bedienungsanleitung PDF herunterladen (Seite 4)

MC1 WALL BRACKET INSTALLATION

1. Locate holes on stud or use hollow wall anchors as shown.

2. Use level to check vertical alignment.

3. Drill holes--5/16" for hollow wall anchors or 3/32" for wood screws.

4. Fasten brackets to wall as shown.

5. Put rubber washer onto bottom bracket post.

6. Install speaker by feeding wires through hollow center of post. Pull excess wires

through lower bracket and set speaker on bottom post.

7. Align hole in top of speaker with hole in top bracket and insert clevis pin.

8. If wall installation is not feasible, an optional floor stand is available.

MC1 INVERTED INSTALLATION

The MC1 may be installed in an inverted position (if you wish to have the wires exit at the top

of the speaker). Invert the brackets during installation. Note that the quasi ribbon driver is

lower with an inverted installation. The inverted position may be desirable where high

frequency dispersion is desired in a sofa or chair which places the listener below the level of

the tweeter. Since the pin may fall out in an inverted position, Magnepan will provide a special

friction pin upon request.

Page 4 of 9

1 2 3 4 5 6 7 8 9

Keine Kommentare

Magnepan MC1 Bedienungsanleitung Seite 4