Magnepan CCR Bedienungsanleitung PDF herunterladen (Seite 11)

CCR Ribbon Tweeter Installation

If the CCR is shipped by ground transportation, the ribbon will be installed in

the CCR. e tweeter will be removed from the speaker only in the event of an

air shipment.

1. Remove 4 screws attaching terminal plate.

2. Remove screws holding rear panel

3. e CCR ribbon tweeter has a white dot at one end of the frame for

determining polarity. Install the ribbon so the end with the white dot can

be attached to the brown wire.

4. Install screws holding the tweeter frame. e tweeter magnets are very

powerful. Use caution to keep magnetic objects from being pulled into the

magnets.

5. Connect the wires to the terminals at both ends of the tweeter.

6. Reinstall the back panel and terminal plate.

Revision—1-19–2015

Page of 11 12

1 2 ... 6 7 8 9 10 11 12

Keine Kommentare

Magnepan CCR Bedienungsanleitung Seite 11