Magnepan CCR Bedienungsanleitung PDF herunterladen (Seite 3)

4 Amplication

e CCR is a 3 ohm speaker and should be used with high current ampliers

that are stable with low impedances. Some receivers are capable of driving low

impedances, but usually separate ampliers are built to higher standards and

are recommended for use with the CCR.

5 Hookup

e CCR employs a unique, high-current connector. To install speaker cable,

simply strip approximately 1/4-inch of insulation from the speaker cable end,

insert the cable and tighten the set screw. Cables terminated with banana plugs

or pins may also be used. For cable terminated with spade lugs, spade lug

adapters are available from your Magneplanar dealer.!

Connect the output of a high pass crossover (such as the Magneplanar XO-2)

to the input of the CCR (observing correct polarity). If the CCR is connected

directly to the center channel amplier, the processor must be set on "small"

center channel speaker. (See Bass Management and Processor Settings section

below for correct settings of the processor.)

6 Installation and Placement

e CCR can be mounted in or on a cabinet or on credenza or shelf. e CCR

is a "small" speaker. (ree felt pads are included to prevent marring of the

bottom surface.) However, a Magneplanar CC Speaker Stand is available for

use with the CCR for use as a full-range, free-standing speaker. e CC

Speaker Stand has a built-in Magneplanar bass driver that utilizes the same

DiPlanar bass technology as the MG 20.1. If the CC Speaker Stand is not used,

some form of adjustable bass management is necessary (See Bass Management

and Processor Settings section below.)

Like all Magneplanars, the CCR is a dipole speaker. We recommend a

minimum of 12 inches clearance, measuring from the back of the CCR to the

surface behind the CCR. Damping material behind the CCR will help tame

unwanted resonances.

Revision—1-19–2015

Page of 3 12

1 2 3 4 5 6 7 8 ... 11 12

Keine Kommentare

Magnepan CCR Bedienungsanleitung Seite 3